To brew loose-leaf tea in a teapot, heat water in a kettle, add leaves to the pot or its infuser, and pour in the measured water. Begin timing as the water reaches the leaves. When the tea reaches the strength you want, pour the infusion out or remove the basket. Leaving the leaves in the water keeps the tea steeping while you drink your first cup.
Teapot, kettle and infuser: what each one does
A kettle heats water. A teapot holds hot water and leaves while the tea steeps. A removable infuser sits in the pot and lifts out with the leaves. A handheld strainer sits over a cup or pitcher and catches leaves during the pour. Keep a ceramic brewing pot off direct heat unless its maker specifically identifies it as stovetop-safe.
If you’ve been given a teapot, lift the lid and look inside. Some have several holes at the base of the spout that hold back large leaves. Others come with a removable basket. Try a water-only pour before brewing to check how the lid sits, where the stream lands and how much drains. If you are unsure whether an older decorative pot was made to hold beverages, check with the maker or a trusted specialist before using it for tea.
Should you put the leaves in a basket or directly in the pot?
Use a roomy basket if you like to brew a pot and pour it a cup at a time. It should reach the water at your intended fill level and have space for the wet leaves to expand. A small tea ball can get crowded with whole leaves that unfurl.
Put the leaves directly in the pot if you want them to move freely. A built-in spout filter can be enough for larger leaves. If fines slip through, pour through a mesh strainer into your cup or a heat-safe pitcher. This also works when you use a ceramic teapot without an infuser.
How much loose tea goes in a teapot?
Base the dose on the water you pour in, using a measuring jug or the change in weight as you add water to the pot. The stated capacity may be a brim measurement. A 400 ml pot used to brew one 240 ml serving calls for a dose for 240 ml. If the tea’s label gives a recipe for 200 ml and you’re pouring 300 ml, multiply the leaf amount by 1.5.
As a starting example, try 2 g of loose black tea in about 240 ml of water. Use the tea maker’s temperature and timing when available. For a black tea whose directions call for near-boiling water and a four-minute steep, start there and taste the result. If the tea is too strong, shorten the next steep or use less leaf. Change one variable at a time so you can tell what helped. Tea Drunk’s teapot brewing ratio · Harney & Sons’ black tea guidance
When to pour, and what to do with the rest
When the timer goes off, decide where the whole infusion will go. If you brewed with a basket, lift it out and set it on a saucer. If the leaves are loose in the pot, pour the entire infusion into cups or a heat-safe pitcher. When brewing for yourself, use a mug that holds the full pour or save the rest in a pitcher.
Begin the next infusion with fresh hot water. Taste it on its own terms. If it comes out weaker, extend the next steep a little. Some leaves still give plenty of flavor on a second infusion, and some are best finished after one serving.
Using a gongfu teapot
For gongfu tea, use a smaller amount of water per round and generally more leaf relative to that water. Make successive short infusions and empty the pot each time. Use the seller’s directions for the tea you have, then adjust by taste. A fairness pitcher makes it easier to share each round among small cups. The same full-pour principle also applies when you brew in a gaiwan.
Clean the pot and infuser after brewing
When the pot is cool enough to handle, tip the leaves into a bin or suitable compost. Rinse the basket from the side opposite the stuck leaf fragments. Use a soft brush if needed and check the pot’s spout holes before setting the pieces out to dry. Leave the lid off for drying. Follow the maker’s instructions, especially if you are switching from a glazed celadon teapot to an unglazed clay pot. How to clean and store glazed and unglazed teaware
For your next pot, record three things: how much water went in, how much leaf you used and when you emptied the pot. Those details make a good cup easier to repeat.